|
| HOME >> TECHNICAL SUPPLY |
 |
| |
|
| |
 |
| |
|
Quick Install Guide |
|
|
| |
| |
 |
| • |
1. Power Supply |
| • |
2. AC on/off switch |
| • |
3. AC voltage switch (Slide switch) |
| • |
4. AC input |
|
| Motherboard/HDD/CD/DVD/Floppy/Peripheral Connector |
 |
 |
 |
 |
20-pin MAIN power
connector |
24-pin MAIN power connector |
20+4-pin MAIN power
connector |
6-pin AUX power
connector |
 |
 |
 |
 |
4-pin 12V(CPU) power
connector |
4-pin peripheral
connector |
SATA power
connector |
4-pin floppy
connector |
| 1.Voltage selection |
For Pseries
  |
Make sure the AC voltage switch is set to the right voltage (115 or 230) section. Incorrect selection of AC voltage will damage the power supply. |
| 2.Install the PSU into PC case |
 |
| PC Case |
|
 |
| Open the PC Case |
|
 |
| made the output wires towards outside |
|
 |
| make sure the fan face bottom |
|
 |
| fix the breechblock |
|
 |
| finish |
|
| 3.Motherboard Connection |
Plug the 20-pin or 24 pin main power connector into M/B mating connector.
．If there are extra connectors on your M/B for 6-pin AUX or 4-pin 12V power support, please
plug in the corresponding connectors.
．If you have high-end graphic card, which requires extra power support, please use PCI-E
connector . This PCI-E connector will provide stable current to your graphic card. |
|
|
|
 |
20-pin MAIN power
connector |
6-pin AUX power
connector |
4-pin 12V(CPU) power
connector |
PCI-E connector
|
| 4.Drives and Peripherals Connection |
| Connect the 4-pin connector, SATA connector and 4-pin floppy connector into the corresponding peripheral. |
|
|
|
|
20-pin MAIN power
connector |
SATA power
connector |
4-pin 12V(CPU) power
connector |
| 5.Check all connectors AGAIN |
PSU On/Off switch
 |
Make sure all devices and peripheral are well connected. Plug the AC cord into AC inlet. Press on/off (I/O) switch to 'I' position, then your system is ready to go. |
|
|
|
|
| |
|
